Search results for "volcanic plumes"

Lidar sounding of volcanic plumes

2013

ABSTRACT Accurate knowledge of gas composition in volcanic plumes has high scientific and societal value. On the one hand, it gives information on the geophysical processes taking place inside volcanos; on the other hand, it provides alert on possible eruptions. For this reasons, it has been suggested to monitor volcanic plumes by lidar. In particular, one of the aims of the FP7 ERC project BRIDGE is the measurement of CO 2 concentration in volcanic gases by differential absorption lidar. This is a very challenging task due to the harsh environment, the narrowness and weakness of the CO 2 absorption lines and the difficulty to procure a suitable laser source. This paper, after a review on r…

Volcanic plume monitoring at mount Etna by diffusive(passive)sampling

2004

This paper reports the use of diffusive tubes in determining HF, HCI, and SO2 in the volcanic plume of Mount Etna in an attempt to highlight the potential of this method in studying volcanoes. In a first application a network of 18 diffusive tubes was installed on Etna's flanks, aimed at evaluating the atmospheric dispersion of the volcanic plume on a local scale. Results showed a monotonic decrease in volatile air concentrations with distance from the craters (HF from 0.15 to <0.003 μmol m-3 , HCl from 2 to <0.01 μmol m -3, and SO2 from 11 to 0.04 μmol m -3 ), revealing the prevalently volcanic contribution. Matching of SO2/HCl and HCl/HF volatile ratios with contemporaneous measurements a…

The bridge volcanic LIdar-BILLI: A review of data collection and processing techniques in the Italian most hazardous volcanic areas

2020

Volcanologists have demonstrated that carbon dioxide (CO2) fluxes are precursors of volcanic eruptions. Controlling volcanic gases and, in particular, the CO2 flux, is technically challenging, but we can retrieve useful information from magmatic/geological process studies for the mitigation of volcanic hazards including air traffic security. Existing techniques used to probe volcanic gas fluxes have severe limitations such as the requirement of near-vent in situ measurements, which is unsafe for operators and deleterious for equipment. In order to overcome these limitations, a novel range-resolved DIAL-Lidar (Differential Absorption Light Detection and Ranging) has been developed as part of…

Development of an active alkaline trap to determine acidic gas ratios in volcanic plumes: sampling technique and analytical methods

2012

Ozone depletion in tropospheric volcanic plumes

2010

We measured ozone (O3) concentrations in the atmospheric plumes of the volcanoes St. Augustine (1976), Mt. Etna (2004, 2009) and Eyjafjallajökull (2010) and found O3 to be strongly depleted compared to the background at each volcano. At Mt. Etna O3 was depleted within tens of seconds from the crater, the age of the St. Augustine plumes was on the order of hours, whereas the O3 destruction in the plume of Eyjafjallajökull was maintained in 1–9 day old plumes. The most likely cause for this O3 destruction are catalytic bromine reactions as suggested by a model that manages to reproduce the very early destruction of O3 but also shows that O3 destruction is ongoing for several days. Given the o…

Volcanic Plume CO2 Flux Measurements at Mount Etna by Mobile Differential Absorption Lidar

2017

Volcanic eruptions are often preceded by precursory increases in the volcanic carbon dioxide (CO2) flux. Unfortunately, the traditional techniques used to measure volcanic CO2 require near-vent, in situ plume measurements that are potentially hazardous for operators and expose instruments to extreme conditions. To overcome these limitations, the project BRIDGE (BRIDging the gap between Gas Emissions and geophysical observations at active volcanoes) received funding from the European Research Council, with the objective to develop a new generation of volcanic gas sensing instruments, including a novel DIAL-Lidar (Differential Absorption Light Detection and Ranging) for remote (e.g., distal) …

Ultraviolet imaging of volcanic plumes: A new paradigm in volcanology

2017

Ultraviolet imaging has been applied in volcanology over the last ten years or so. This provides considerably higher temporal and spatial resolution volcanic gas emission rate data than available previously, enabling the volcanology community to investigate a range of far faster plume degassing processes than achievable hitherto. To date, this has covered rapid oscillations in passive degassing through conduits and lava lakes, as well as puffing and explosions, facilitating exciting connections to be made for the first time between previously rather separate sub-disciplines of volcanology. Firstly, there has been corroboration between geophysical and degassing datasets at ≈1 Hz, expeditin…

Advances in Bromine Speciation in Volcanic Plumes

2018

Volcanoes are a significant halogen source to the atmosphere. After water, carbon dioxide and sulfur compounds, halogens are often the most abundant gases in volcanic plumes. In the past, less attention was given to the heavy halogens bromine and iodine. However, the discovery of bromine monoxide (BrO) in volcanic plumes led to new interest especially in volcanic bromine chemistry and its impact on atmospheric processes. The BrO detection came along with advances in volcanic remote sensing techniques, in particular, robust DOAS applications and the possibility of continuous measurements by automated instruments located at safe distances from the volcano. As one of the consequences, the volc…